Knowledgebase
|
Brother DR-360 Drum reset procedure
Posted by Richard Waugh on 16 May 2012 12:17 PM
HL SERIES: Put the drum unit into the printer leaving the door open. Press and hold the white "GO" button until all the LED's cycle through and light up. Close the front door. (Note: same as the DR-350 instructions) MFC SERIES: Put drum unit in the printer leaving the front door open. Press CLEAR/BACK. Press "1" to confirm your replacing the drum. Close the front door. DCP SERIES: Put the drum unit into the printer leaving the front door open. Press CLEAR/BACK. Press "UP ARROW" until the LCD shows "ACCEPTED". Close the front door. |
|
 (2 vote(s)) This article was helpful This article was not helpful |
|
Comments (0)
